Taig SILVER Lathe Package


Taig Micro Lathe II semi assembled and includes:

  • 3 Jaw 3¼" diameter self-centering Scroll Chuck (steel body) with reversible aluminum soft jaws ¾-16 thread
  • 0-¼" Jacobs drill chuck commercial quality 3/8-24 thread
  • Drilling tailstock lever operated 5/8" off set with dead center 3/8-24 thread for drill chucks
  • Polyurethane V-belt (established belt life of 5 000 hours) 12½" flat length
  • 6 Step pulley for headstock spindle
  • Cross slide
  • Tool post
  • Carriage depth stop
  • Chuck depth stop for workpiece in chuck
  • Lathe dog for turning between centers
  • Collet set: 1/8" 5/32" 3/16" 7/32" 1/4" 9/32" 5/16" 1 blank
  • 6 Piece high speed steel tool bit set: 1 each of left hand, right hand, 45 degree chamfer , round nose, boring bar, cut off tool bits (box no longer included)
  • Needle bearing centre
  • "The Taig Lathe" comprehensive handbook by Tony Jeffree
  • 240V DC Variable speed motor (0 to 2,400 rpm*)
  • 2 Step pulley for motor spindle
  • Motor mounting bracket for headstock
  • Mounting bracket spacer

*motor spindle speed from 0 to 6,100 rpm; use of the 6 step pulley permits speeds of up to 10,000 rpm, but comes belted using the largest pulley, which ratios the speed down to 2,400 rpm.

Please note this machine will require assembly and installation on a mounting board (not supplied). The photograph shows what an assembled machine could look like.

Instructions on lathe assembly can be found here

The items that are bolded are extra over Taig BRONZE.

For complete list of Taig Specifications, Technical Drawing and Parts.

You can include the new Power Feed accessory below and have it installed by the factory.

Sold Out
  • Model: 6-1001
  • Shipping Weight: 15kg
  • 0 Units in Stock

Ask a question about this item

Please Choose:

Customers who bought this product also purchased...

Your IP Address is:
Copyright © 2022 Taig Australia. Powered by QAPS Group